Thar Tech pilot plant model RESS 250

Equipment with agitation for impregnation of porous matrices fully automated. It consists of:

• a high pressure pump
• a 250 mL stainless steel extractor vessel surrounded by an electric heating jacket
• a magnetic stirrer with a maximum speed of 2500 rpm
• a stainless steel collecting vessel
• a FlexCOR coriolis mass flowmeter

Iberfluids pilot plant model SAS

Fully automated equipment for deposition of nanoparticles in solid matrices capable of operating in a pressure range up to 350 bar and 100ºC temperature. It consists of:

• a 500 ml precipitator vessel
• a high pressure pump for solvent injection with a flow rate between 1-50 g/min
• a high pressure pump for CO2 injection with a flow rate between 5-200g/min
• a 500 mL cyclonic separator to separate CO2 and organic solvent
• an automated back pressure regulator
• a Temperature controller
• a heat exchanger
• a cooling bath to keep CO2 below 5ºC
• a plant control computer with software installed. In addition, CD software is available for possible reinstallations
• nozzles of 100, 150  and 200 micras diameter

Iberfluids pilot plant model SSI

Fully automated equipment for deposition of nanoparticles in solid matrices capable of operating in a pressure range up to 400 bar and 100ºC temperature. It consists of:

• a 500 ml solubilization chamber
• a 500 ml impregnation chamber
• a high pressure pump for solvent injection with a flow rate between 1-50 g/min
• a high pressure pump for CO2 injection with a flow rate between 5-200g/min
• a 500 mL cyclonic separator to separate CO2 and organic solvent
• an automated back pressure regulator
• a Temperature controller
• a heat exchanger
• a cooling bath to keep CO2 below 5ºC
• a plant control computer with software installed